D5D NTSC/PAL to Serial Decoder User Manual December 5, 2003 P/N 101632-04
Trademarks AJA, Io, and Kona are trademarks of AJA Video, Inc. All other trademarks are the property of their respective holders. Notice Copyright © 2003 AJA Video, Inc. All rights reserved. All information in this manual is subject to change without notice. No part of the document may be reproduced or transmitted in any form, or by any means, electronic or mechanical, including photocopying or recording, without the express written permission of AJA Inc.
AJA D5D NTSC/PAL To Serial Decoder User Manual — Introduction Introduction The D5D Serial Digital Decoder provides low-cost all-digital decoding of analog NTSC, PAL or Y/C (S-Video) to 4:2:2 component serial digital. When working in a serial digital environment, the D5D is useful for bringing in video from time-base corrected analog composite equipment. The D5D provides three 4:2:2 component serial digital outputs.
I/O Connections Composite or Y/C Inputs Serial Digital Output 1 Configuration Determined by DIP switch on other side of Converter Serial Digital Output 2 + 5VDC Power Input Serial Digital Output 3 D5D, Side View User Controls The user interface for the D5D is a 4-position DIP switch accessible through a cut-out in the bottom of the unit. Use the DIP switches to configure inputs for Y/C or Composite, set blanking and pedestal, and configure the comb filter.
AJA D5D NTSC/PAL To Serial Decoder User Manual — Installation Switch 3—Configure Pedestal For Composite/Sync BNC : ON OFF 7.5 IRE pedestal for NTSC No pedestal (for inputs without Pedestal) Switch 4—Configure Comb Filter : Input Selection Matrix (2 BNCs) ON OFF Selects a three line adaptive comb filter (one line plus a 1.5us delay) Selects a two line non-adaptive1comb filter (1.5 us delay) The following table shows the combinations of DIP switch settings required to configure the two input BNCs.
Specifications Item Specification Inputs NTSC/PAL, or Y/C (S-Video), 2 BNCs Outputs SDI (SMPTE 259M), 3 BNCs All outputs are separately buffered Frequency Response +/- 0.25 dB to 5MHz 2T K factor < 1.0% (Y) Differential Gain < 1 .5% Differential Phase < 1 .5 degree Input level adjustment (internal) +/-10% User Controls Externally accessed DIP switch Power (AJA power supply model DWP) 5v DC regulated, 3.5 watt Size 5.1" x 2.