www.aja.com D5PSW SDI Protection Switch Published: 5/24/11 Installation and Operation Guide May 24, 2011 B e c a u s e i t m a t t e r s .
Trademarks AJA®, KONA®, Ki Pro® and XENA® are registered trademarks of AJA Video, Inc. Io HD™ and Io™ are trademarks of AJA Video, Inc. HDMI, the HDMI logo and High-Definition Multimedia Interface are trademarks or registered trademarks of HDMI Licensing LLC. DVI is a registered trademark of DDWG. All other trademarks are the property of their respective holders. Notice Copyright © 2011 AJA Video, Inc. All rights reserved. All information in this manual is subject to change without notice.
AJA HD10CEA SDI/HD-SDI to Analog Audio/Video Converter Introduction The D5PSW accepts 2 SDI inputs, Primary and Secondary, and automatically switches to the Secondary input if the Primary input is not present or is not a valid SDI signal. An SDI input is considered valid if a proper SMPTE 259 stream is present.
I/O Connections SDI Output 1 BNC SDI Output 2 BNC SDI Primary Input BNC LED* SDI Output 3 BNC SDI Secondary Input BNC + 5 VDC Power Input *LED indicator: Green if both Primary and Secondary are present Flashing green if the Primary is present but the Secondary is not present Orange if the Secondary is present but the Primary is not D5PSW, Side View Installation Typically, D5PSW installation consists of the following: 1. disconnect +5VDC from the convertor 2. connect video equipment to the BNCs 3.