Instruction manual

10
The close-captioning status screen shows whether closed caption data is present on
the selected video input.
The AJA logo is displayed when no button activity occurs for 60 minutes.
The FS1’s System Name has been previously defined (how to enter/edit it is
described in Chapter 4, Parameter Menus, System Name 50.5).
Controlling the
FS1 Using the
Select and Adjust
Buttons
The FS1's control system is designed to be easy to use and remember. All
functions in the menu system are numbered for easy reference. Two pairs of up/
down buttons named Select and Adjust provide control. Pressing any of these four
buttons immediately puts the FS1 into control mode:
To operate the FS1, use the Select buttons to select a function or parameter. Then
use the Adjust buttons to adjust the selected function or parameter.
The control display has two lines:
The top line contains a numbered and named FS1 parameter and or function.
The lower line contains the current setting.
The parameter Select buttons select a parameter to view or modify.
Pressing a parameter Adjust button changes the current parameter's value to a new
one from the FS1's list of choices—repeating the list if you continue to press
Adjust or adjusting a numerical value up or down. The exact choices displayed
will vary depending on the parameter. Adjustment choices made with the
Adjust buttons take effect immediately (except 1.1 Output Format which has a
1/2 second delay). In most cases, changed parameters will be stored into the
FS1’s non-volatile memory after the parameter remains unchanged for 3
seconds. Exceptions are the IP Address, IP Config, Subnet Mask and all SNMP
parameters; for these you must exit the selection to activate changes.
Holding down a Select or Adjust button continuously changes the choices
automatically with acceleration if applicable.
Pressing either a Select or an Adjust button while on the Status or Screen Saver
displays changes the display to the last remembered control menu.
Holding down both the Adjust (up) and Adjust (down) buttons—at the same time
will set that parameter back to its factory default value.
For some parameters, once the parameter is selected, the first Adjust button
pressed begins the editing. The top Select button then can be used to choose
the position (left to right) within the parameter being edited.
Parameter Number and Name
Current Parameter Setting
Select
Adjust