Instruction manual

70
51.3 SNMP Trap Port 1
This parameter determines the SNMP Trap Port used for sending destination #1
trap messages. UDP Port 162 is the default used for SNMP trap messages. However,
if this port is being used by another protocol or service, you can change the setting
by modifying this parameter.
Note: The SNMP Trap Port number does not blink when changed (as does the
Trap Destination IP address); if you change the port number and exit the parameter
(moving to another parameter), the port will change immediately as edited.
51.4 SNMP Trap Destination 2
This parameter determines the secondary SNMP Trap Destination IP address where
trap messages issued by the FS1 will be sent (if desired).
When the SNMP Trap Destination IP addresses are edited, you can abort the editing
process by backing out (press the Select down arrow button repeatedly until the edit
passes the first octet). You’ll notice that after completing the edit on the last octet,
the display will blink—this is an indication that the edited IP address is about to be
saved. You can save the edited IP address by pressing the Select up arrow to save or
choose not to save by pressing the Select down arrow button.
51.3 SNMP Trap Port 1 Description of Choices
Parameter Adjustments:
variable Using the Adjust buttons, select a UDP port for sending FS1 trap messages.
Default: 162
51.4 SNMP Trap Dest 2 Description of Choices
Parameter Adjustments:
variable Using the Adjust buttons, enter the IP address of the destination where SNMP
command messages (called “traps”) will be sent. This is usually an SNMP client
somewhere on your LAN.
Default: 192.168.0.3