User Manual
Table Of Contents
- Installation & Operation Guide
- Trademarks
- Copyright
- Contacting Support
- Overview
- System Requirements
- What’s In The Box?
- In This Manual
- Installation Overview
- Connecting to your Computer
- Installing Io XT/4K Software
- Using Io XT/4K with Professional Video /Audio Software
- AJA Control Panel Overview
- Control Panel Operation
- Using Io 4K for UHD/4K
- If You Run Into Problems
- Updating Software
- Support
- Io XT Specifications
- Io 4K Specifications
- Machine Control
- Appendix B: Safety and Compliance
- Federal Communications Commission (FCC) Compliance Notices
- Canadian ICES Statement
- European Union and European Free Trade Association (EFTA) Regulatory Compliance
- Korean Compliance Statement
- Taiwan Compliance Statement
- Japanese Compliance Statement
- Translated caution statements, warning conventions and warning messages
- Before operating your AJA unit, read the instructions in this document
- Limited Warranty
- Limitation of Liability
Io XT/4K v10.5r2 www.aja.com
36
HDMI Screen The Io XT/ 4K HDMI input and output are configured at this screen. For Io 4K UHD and 4K
format setup, see “HDMI Screen in 4K Mode” on page 50.
Figure 32. AJA Io XT HDMI, HDMI Screen
HDMI Output Settings The Source pulldown menu allows you to select either the primary video format
(framebuffer) or (if conversion is supported) a secondary one (up/down/cross-
conversion).
Pulldowns are also provided for configuring the video output range, color space and
number of embedded audio channels (2 or 8) for the HDMI output. A Protocol pulldown
allows you to choose either “HDMI” or “DVI” protocol—use DVI if you’re outputting to a
DVI monitor using an HDMI to DVI adapter.
A pulldown menu for 3D output allows you to select either Side-by-Side or Top-Bottom
(Stacked) output of left-eye and right-eye signals.
NOTE: This selection must agree with format selection in the third-party CineForm Codec
(NOT included with AJA Io XT) pulldown menu.
Audio Channels: An Audio Channel pulldown allows you to select the number of embedded audio
channels for the HDMI output.
HDMI Input Settings The detected HDMI input video format is displayed and you’re given a chance to
configure the RGB range (SMPTE or FULL) and select any two embedded channel pairs
from those supplied for stereo output (if applicable).