Specifications
Table Of Contents
- Installation & Operation Guide
- Trademarks
- Copyright
- Contacting Support
- Overview
- System Requirements
- What’s In The Box?
- In This Manual
- Installation Overview
- Connecting to your Computer
- Installing Io XT/4K Software
- Using Io XT/4K with Professional Video /Audio Software
- AJA Control Panel Overview
- Control Panel Operation
- Using Io 4K for UHD/4K
- If You Run Into Problems
- Updating Software
- Support
- Io XT Specifications
- Io 4K Specifications
- Machine Control
- Appendix B: Safety and Compliance
- Federal Communications Commission (FCC) Compliance Notices
- Canadian ICES Statement
- European Union and European Free Trade Association (EFTA) Regulatory Compliance
- Korean Compliance Statement
- Taiwan Compliance Statement
- Japanese Compliance Statement
- Translated caution statements, warning conventions and warning messages
- Before operating your AJA unit, read the instructions in this document
- Limited Warranty
- Limitation of Liability
Io XT/4K v10.5r2 www.aja.com
48
Configuring Quad
SDI I/O
This section describes the AJA Control Panel operations specific to UHD/4K Format
selection.
Output Configuration: When you use the Control Panel Format screen to select a UHD or 4K format for the Io 4K
output, you must also make sure the default output mode (Control screen setting) is set
to “Test Pattern.” Then the SDI connectors 1–4 will automatically configure as outputs
(see Figure 46).
Figure 45. Control Screen setting for 4K Output
NOTE: When you select a UHD/4K format, the HDMI monitor output can be set to Full (shown below)
or will display the Output Mode selection icon (as shown on the SDI Mon output) when a
quarter or quadrant output signal is selected (see “HDMI Screen in 4K Mode” on page 50 for
output options).
Figure 46. Io 4K Format Screen with 4K Format selected.