Specifications
1
23
Ki Pro Installation and Operation Manual — Installation
Applying Power The installation and set up of a Ki Pro is straight-forward. If you’ll be controlling the unit
from the front panel buttons and display, it’s ready right out of the box. Just cable the
system’s audio and video sources, VTR(s), monitors, and audio equipment, mount the Ki
Pro unit as desired, and begin recording. However, if you wish to control Ki Pro from a
web browser or 802.11 device (iPhone etc.), then there are additional configuration
steps necessary.
Warning!
Since the Mains plug is used as the disconnection for the device, it must remain
readily accessible and operable.
Warning!
Protect the power cord from being walked on or pinched particularly at plugs,
convenience receptacles, and the point where they exit from the device.
Warning!
Unplug this device during lightning storms or when unused for long periods of
time.
Warning!
Do not open the chassis. There are no user-serviceable parts inside. Opening the
chassis will void the warranty unless performed by an AJA service center or licensed
facility. Remove the supplied AC line cord from mains power when moving the unit.
Do not defeat the safety purpose of the grounding-type plug.
Using AC Power
To begin using Ki Pro, plug the 4-pin XLR on the supplied AC adapter into the XLR
power socket on the back of Ki Pro. Then plug the AC adapters line cord into 110 VAC or
230 VAC (the supply is autosensing).
Using DC Power
To run Ki Pro on DC power, simply plug a 3rd-party industry standard 12 volt battery
pack with a 4-pin female XLR connector into the side power connector on Ki Pro. The
battery should be capable of supplying a sustained 3.3 A (just like the supplied AC
Adapter provides). Such battery packs are available from a variety of sources.
Notes: To operate Ki Pro properly, batteries should not have voltage lower than 12 volts and
should not have voltage that exceeds 18 volts.
Ki Pro consumes approximately 30 watts of power so many batteries can power Ki Pro for
several hours at a time.
1. Locate Line Cord 2. Insert into DC supply 3. Insert 4-pin XLR into
12Vdc Ki Pro power socke
t