Specifications
1
49
Ki Pro Installation and Operation Manual — CONFIG menus
50.3 SUBNET MASK
This parameter determines the subnet mask used by Ki Pro for TCP/IP networking.
Please read the “Note” about editing IP addresses in parameter 50.2 as it also applies to
parameters 50.3 and 50.4.
50.4 STATIC GATEWAY
This parameter determines the gateway or router used by Ki Pro on your LAN for TCP/IP
networking.
Note: Without a properly configured default gateway (whether you have a router/gateway or
not), Ki Pro will be unable to see other Ki Pros on the network, although you may still be
able to control the Ki Pro via a web browser. Also, without a proper gateway defined, the
discovery feature “Available Ki Pros—Click to Refresh” on the Network web page will not
work correctly and list other Ki Pros on the network.
50.5 SYSTEM NAME
This parameter defines a name for Ki Pro and gives it a unique identifier. This same
name is used both when displaying systems via the web interface/802.11b/g and for
display on Ki Pro’s screen saver (if System name is chosen in Parameter 70.1 Screen
Saver).
50.3 SUBNET MASK
variable
Using the adjust buttons, enter a subnet mask compatible
with your LAN (if you have one). This is only needed for
Static IP configurations.
If 50.1 is set to
DHCP,
the default
Subnet Mask
will be
assigned by the DHCP server
If 50.1 is set to
Default Addr,
the default
Subnet Mask
is:
255.0.0.0
50.4 STATIC GATEWAY
variable
Using the adjust buttons, enter a gateway compatible with
your LAN (if you have one). This is only needed for Static
IP configurations.
If 50.1 is set to
DHCP,
the default
gateway
will be
assigned by the DHCP server
If 50.1 is set to
Default Addr,
the default gateway is:
10.0.0.1
50.5 SYSTEM NAMEE
variable
Using the adjust buttons, enter a name for Ki Pro. Using
the adjust buttons and the top Select button, select the
characters for each of the up to 20-character name. The
adjust buttons scroll through the choices and the top
Select button advances to the next character. While
selecting characters, the character being changed will
flash to show its position. The character set allowed is: 0
through 9, '-','.', A through Z (uppercase) and a through z
(lowercase).
Default:
aja-kipro