Installation and Operation Manual

KONA Capture, Display, Convert v15.5 40 www.aja.com
SDI RGB Rng
Sets the RGB range. Select from Auto, SMPTE, or Full.
LTC/Ref (KONA 5, KONA 1)
KONA 5 and KONA 1 cards support LTC on the Reference. Select from:
• Reference - Receives only reference on the Reference input
• Ref + LTC - Receives both reference and timecode on the Reference input
• LTC - Receive only timecode on the Reference input
Audio Input
Select
The select pulldown menu allows you to pick where the audio comes from.
Different KONA cards have different audio input capabilities. Select from:
• Auto - In 8K Mode, defaults to SDI 1 Ch1-16
• AES/EBU (BNC)
• SDI 1 Ch1-16
• SDI 2 Ch1-16
Ch Map
If only two channels were selected in the third-party application you are using,
you can select which two channels will be mapped to that application. Different
Audio Input selections can have different channel mapping capabilities. Select
from:
• 1-2 to 1-2 (default)
• 3-4 to 1-2
• 5-6 to 1-2
• 7-8 to 1-2
• 9-10 to 1-2
• 11-12 to 1-2
• 13-14 to 1-2
• 15-16 to 1-2
NOTE: This setting does not affect the embedded audio being sent to the KONA's BNC or
HDMI output connectors.
SDI Output Screen
The Control Panel SDI Output screen is different, depending on the KONA device
and the operating firmware.
On KONA 5 and KONA 4 in 4K Mode, and on KONA 1, and the SDI Output screen is
used to configure the KONA card's SDI Output signal.
NOTE: If all KONA card SDI output BNC connectors are not required for the currently
configured transport, the same SDI signal will be routed to both SDI output BNC
connectors.