Instruction manual

1
11
KONA LH/LHe Installation and Operation Manual — Cable Connections
Using KL-box The KL-box attaches to the KONA LH card via cables that attach to the back of the
KL-box. These cables are supplied with the KL-Box (one 60-pin to 60-pin, and one 3-
BNC to 3-BNC). When you purchase the optional KL-Box, you get two-channel
unbalanced audio output (2 RCA Jacks)—not available with the standard cable.
Note: When ordering a KL-Box, ensure that you specify one configured for the
KONA LH/LHe. The KL-Box is also available for the KONA LS and LSe, but uses a
different cable set when ordered for the LS card. Separate AJA part numbers exist for
each configuration, so ensure your dealer supplies you with the correct one.
AJA KL-box Panel Connectors
About BNC
Connectors
Although most video professionals are used to BNC connectors, you may not have
seen them if you’ve been using primarily desktop video equipment. BNC connectors
ensure a positive connection by the act of locking the connectors together via pins in
one connector that fit into slots in the corresponding connector.
To make a BNC connection, slide the cable connector over the panel connector and
then when seated, rotate the barrel of the cable connector 90˚ clockwise until the
connectors are locked together. When properly locked, the cable cannot accidentally
be pulled out.
RS422
Machine
Control
External
Reference
(loop)
Analog Audio
Output
Balanced Audio In
Channels 1 & 2
Balanced Audio Out
Channels 1 & 2
Composite/
Component
Video In
Composite/
Component
Video Out
AES/EBU Audio
In and Out
In
Serial
Digital
Out
Serial
Digital
Pins (2) on BNC Connector
Align slots in
cable connector
barrel with connector
pins, then slide it over the pins
and rotate the barrel
to lock the connectors
(connector on KL-box)
together