Instruction manual

46
KONA LH Control Panel, Formats Tab Showing Conversion Pulldown Menu
Format Screen Settings
Video Format—This pull-down menu shows the currently selected format. This
pull-down appears in both the Primary Format area of the Formats screen as
well as the Secondary Format area (if present). If you select an alternate value in
the Primary Format using the pull-down, it will change the format used by
KONA LH’s framebuffer. Video Format can only be changed when the
Control Tab menu has the setting “Input Pass through”. When a change is
made via the Video Format pull-down, the block diagram will change to reflect
the new format.
In the case of Secondary Format, the formats available can vary based on what
the Primary Format is and the input signal (frame rates of input sources limits
the to/from conversion choices). The “Secondary Video Format” pull-down
menu lists all formats with those that are incompatible shown in gray (these
can’t be selected). This allows you to see what you've chosen, and also see those
formats that are incompatible with the selected Primary format.
KONA LH Formats include:
525i 29.97
625i 25
720p50
720p 59.94
720p 60
1080i 25
1080i 29.97
1080i 30
1080sf 23.98
1080sf 24
Note: The AJA Control Panel software uses the abbreviation "sf" instead of "psf"
when referring to "progressive segmented frame". In the manual and in other
literature you may see either of these acronyms used interchangeably.
Down (Conversion)—Choices that may be available:
Anamorphic: full-screen
Letterbox: image is reduced with black top and bottom added to image area with