RD5AD 2-channel Component/Composite Analog to SDI Converter R-series Card Module User Manual October 25, 2003 P/N 101644-00
Trademarks AJA, Io, and Kona are trademarks of AJA Video, Inc. All other trademarks are the property of their respective holders. Notice Copyright © 2003 AJA Video, Inc. All rights reserved. All information in this manual is subject to change without notice. No part of the document may be reproduced or transmitted in any form, or by any means, electronic or mechanical, including photocopying or recording, without the express written permission of AJA Inc.
AJA RD5AD 2-Channel Analog to SDI Converter User Manual — Introduction Introduction The AJA Video RDSAD is a dual-channel universal video A/D converter. The RD5AD supports 2 completely separate channels of analog to SDI conversion and is useful for video/key or video/video applications. Both channels can be independently configured for YPbPr (SMPTE, EBU-N10), Betacam, RGB, composite or Y/C (SVideo) inputs.
I/O Connections Serial Out R/Pr/C B/Pb Channel 1 Channel 1 Channel 1 J8 J6 J4 J2 J9 J7 J5 J3 G/Y/Comp Channel 1 B/Pb Channel 1 J1 Serial Out Channel 2 R/Pr/C Channel 2 B/Pb Channel 2 not used G/Y/Comp Channel 1 not used G/Y/Comp Channel 2 FR1 Frame Layout RD5AD Rear Panel R/Pr/C Channel 1 Serial Out Channel 1 J1 J3 G/Y/Comp Channel 2 J5 B/Pb Channel 2 J7 R/Pr/C Channel 2 J2 J4 J6 J8 J9 Serial Out Channel 2 FR2 Frame Layout RD5AD Rear Panel FR1 and FR2 BNC Connector Assign
AJA RD5AD 2-Channel Analog to SDI Converter User Manual — Installation Control Functions Switch Position Functions (applies to dipswitches for both channels) S1 Input Selection: ON (Down) = Composite OFF (Up) = Component S2 Input Selection: ON (Down) = RGB— if SW1 is up the Input will beRGB if SW1 is down Input will be Composite OFF (Up) = YUV/YC—if SW1 is up Input will be YUV if SW1 is down Input will be YC 1 S3 Input Selection: ON (Down) = SMPTE/EBU-N10 Levels OFF (Up) = BETACAM 525 levels S4 Bl
Specifications Item Specification Input Format: SMPTE, EBU N-10, RGB, BETACAM, NTSC, PAL, Y/C (S Video) Output Return Loss: 15 db to 300 Mhz FrequencyResponse: +/-0.25 db to 5 Mhz (Y) +/-0.25 db to 2.5Mhz (Chroma - Component, RGB) +/-0.25 db to 1.3Mhz (Chroma- Composite) Delay: With Comb Filter OFF: 1.3 usec With Comb Filter ON: l line + 1.3usec Digital Adjustments: Output Gain: +/- 10% Offset: +/- 10% Saturation: +/- 10% K factor: <1% 2T (Y) Diff. Gain: <1.5% Diff. Phase: <1.
