Owner`s manual

AJP PR4 User’s manual - 3
rd
Edition Page
29
If oil level is below Min, oil must be
refilled immediately. If you check that
engine is losing oil (for instance at oil
radiator or oil tubes in 200/240 cc
engines), contact your AJP dealer
immediately.
! WARNING !
Insufficient engine oil or poor
quality may cause severe damage
to the engine.
Never operate your motorcycle with
low engine oil level or with non-
adequate engine oil quality.
! CAUTION !
Engine oil level should be checked
daily or before any ride. If necessary
you should add oil to keep always oil
level between maximum H mark and
lower L mark.
! WARNING !
On PR3 200/240, if any oil pipe or oil
radiator is damaged and present leak,
engine should be immediately stopped.
Otherwise serious damages in engine
will happen due to lack of oil in
lubricating circuit.
Changing engine oil (*)
Engine oil has to be changed with the
engine being at operating temperature.
! CAUTION !
An engine at operating temperature
and engine oil it contains are very
hot. Please take all cares to avoid
burning yourself.
Place the motorcycle on a horizontal
surface, remove the oil filter cover (that
works as drain plug) and allow the oil to
drain into a receptacle. Never drain
used oil to the ground, waste, water
lines or sewage.
Take out the oil drain together with oil
filter, clean these components carefully
and blow with compressed air. Check
o-ring and sealing and replace them if
necessary.
Once the entire oil has been drained,
clean the sealing surface, mount the oil
drain (1) together with spring (2), oil
filter (3) and sealing (4) on the right
position and tighten up to 15Nm (1,5
Kg.m).
Screw aluminium drain carefully to
avoid damaging carter’s thread.
Remove the oil dipstick (1) and fill in
with recommended quantities:
Ma
x
Min
1
1
4
2
3