Owner`s manual

AJP PR4 User’s manual - 3
rd
Edition Page
36
To recharge PR4 YTX5L-BS battery,
use a appropriate 12V charger.
Connect first charger terminals to
battery and then plug charger plug to
network electric power (220V).
Read carefully charger instructions
before use charge rand follow de
specified charger method.
Charge
method
Charge
current
Charge
time
Normal 0,6 Amps
5 to 10
hours
Fast 3,0 Amps 1 hour
! WARNING !
Fast charge is not recommended.
Use this method only in emergency
cases;
When replacing, if new battery is
already charged, always apply an
initial charge, according to
manufacturer’s instructions.
!WARNING!
When assembling, never switch
polarity, once you may destroy battery
and rectifier
Never disconnect battery when engine
is running. Rectifier may be destroyed.
FUSE
The fuse is disposed underneath the
seat. Having removed the seat you will
be able to see the fuse.
The fuse capacity is 20 Ampere.
Always carry an extra fuse in the fuse
holder with you whenever you are riding
the motorcycle.
Replace a blown fuse only with an
equivalent one. If a new fuse that has
just been set in gets blown again, you
are strongly advised to have it
inspected by an AJP dealer.
! CAUTION !
Under no circumstances is a
stronger fuse allowed to be set in
or a fuse to be “repaired”. An
inadequate treatment could
damage the whole electrical
installation.
Plastic covers should always be
correctly placed in their correspondent
support in order to avoid any fuse to be
lost.
LIGHT BULB REPLACEMENT
Low beam light
Use only 12V35/35W BA20d lamps.
Loosen both rubber bands and tilt
headlight mask to the front.
Remove rubber cover, lose retaining
clip and remove carefully lamp support
out of headlight glass.
Press lamp inside, rotate it counter
clockwise and remove it away from
holder.