Owner`s manual

AJP PR4 User’s manual - 3
rd
Edition Page
38
Press lamp, rotate it counter clockwise
to remove it.
Install a new lamp on blinker holder;
Note: After installing the lamp on lamp
holder, clean it with a wet alcohol cloth,
to clean any finger print that may origin
hot spots that may reduce lifecycle of
headlight lamp.
Fit inner globe (Orange) and blinker
glass, aligning groove by blinker body.
Note: Drain groove in each blinker must
be facing down.
STICKER REPLACEMENT
Note: we recommend fully reading of
this instructions before apply new
stickers.
Surface preparation
Remove old stickers and wash plastics
carefully with water and soap.
Remove eventual grease sediments
with an appropriate grease solvent (pay
extra attention near fuel tank)
After plastic cleaning, wash hands and
dry them.
We recommend apply new stickers in a
clean, dry and warm place.
Sticker application:
Start by graphic alignment.
In stickers with holes, start with them. In
stickers without holes, use paper strip
to limit.
Peel off one end of the protective role
of the sticker and start gluing it on the
plastic part.
Do not press immediately without
confirming the alignment;
Once properly aligned, continue with
the removal of paper / glue sticker.
Press the adhesive from the interior to
the edges to avoid formation of air
balls, using a spatula.
For a perfect grip, use a hot air blower
(ordinary hair dryer); Apply hot air for 5
seconds at a distance of 5-7 cm and
then pressing with a spatula.
Let stand for 48 hours the stickers
before starting any sporting activity or
cleaning.