User's Manual

Step 5 – Testing the Board
Before reassembling the marker, you should do
a quick test to make sure that connections are
correct and that the board is working. Making
sure that nothing is grounding the grip frame,
move the power switch to the on position. If
everything is working, you should see the LED
light up orange. If this occurs, turn the power
switch to the off position and continue to step 6.
If you don’t see the LED light up, make sure
your battery is connected. If that is not the
problem, then check the connector plugs. If you
require further assistance, please email the
technical support department
([e-mail]).
Step 6 – Reassemble the Marker
Reassemble your marker by attaching the grip
frame to the body, and using the two screws to
hold them together.
Congratulations! You have now successfully
completed the installation of your Equalizer
TM
board!
NOTE: The Equalizer board can be used with
either the Viking or Excalibur markers. The
Equalizer detects which marker it is installed
in, and adjusts parameters to handle the
different firing sequences and eyes modes.
SECTION 2 – USAGE
The Equalizer
TM
has numerous features,
which can be a bit overwhelming to those
that are not use to having so much
flexibility.
The Boot Sequence
When the Equalizer
TM
boots up, the LED will light
up orange and then either green (NORMAL
mode) or red (COMPETITION mode).
Feature Descriptions
Dwell
Dwell is the amount of time that the
solenoid will be activated. This time is
measured in milliseconds (1/1000
th
of a
second). The user can alter the Dwell only
when in NORMAL mode. In COMPETITION
mode, it is not possible to change settings
via the trigger programming. The factory
default is 8.0ms. Changes can be made in
.1ms units via the Equalink.
Increasing your Dwell will increase the
velocity of your marker. If you are
experiencing a great variance in your
chrono results, try increasing your Dwell.
If your dwell is too low, consistency will
suffer greatly.
Debounce
Debounce is the amount of time the trigger
switch must be stable in the up position
before checking for another trigger pull.
This time is measured in milliseconds. The
user can alter the Debounce only when in
NORMAL mode. Possible values are from
1ms to 255ms. The factory default is 10ms.
Changes are made in 1ms units.
If you find that your marker is double firing,
increase the Debounce time. To make your
marker fire faster due to being more