User's Manual

C. BALL DETENTS.
2004 EXCALIBUR® & VIKING™ BALL
DETENT.
The ’04 EXCALIBUR® and ’04 VIKING™
has been supplied with a dual ball detent to
keep paintballs from double feeding and to
keep paintballs centered directly in the
breech for better detection by eyes when
installed.
Replacement of dual ball detent:
The dual ball detent may need cleaning or
become worn or broken over time. This is
normal. The ’04 EXCALIBUR® and ’04
VIKING™ detents are available through your
local dealers or AKA.
To replace the detent.
1. Remove the two 4-40 button head screws.
2. Lift the cover plate away from the body of
the EXCALIBUR® or VIKING™
3. Remove the detent springs.
4. Remove the ball detents.
5. Clean and replace parts that are needed.
6. Re-install the ball detents, the springs, the
cover plate and the two screws. Do not over
tighten, just snug them down.
Ball Detent Parts Chart:
Part Description: Qty: Part
Number:
Ball detent cover plate 1
Plastic ball detents 2
Detent springs 2
4-40x.250 Button head screws 2
2004 EXCALIBUR® and VIKING™ DETENT
2000-2003 EXCALIBUR® and VIKING™
WIRE BALL DETENT.
The EXCALIBUR® and VIKING™ has been
supplied with a wire ball detent to keep
paintballs from double feeding.
Replacement of ball detent:
The wire ball detent may need cleaning or
become worn or broken over time. This is
normal. The EXCALIBUR® and VIKING™
uses an F4 wire nubbin. They are available
through your local dealers or AKA.
To replace the detent.
1. Remove the two 4-40 button head screws.
2. Lift the cover plate away from the body of
the EXCALIBUR® or VIKING™.
3. Remove the detent and replace with a new
one.
4. Re-install the cover plate and the two
screws. Do not over tighten, just snug them
down.
Ball Detent Parts Chart:
Part Description: Qty: Part
Number:
Ball detent cover plate 1
F4 ball detent 1
4-40x.250 button head screws 2
2000-2003 EXCALIBUR® and VIKING™
WIRE DETENT.