User's Manual

2004 EXCALIBUR® Ram Parts:
Part Description: Qty: Part Number:
H-bar 1
Ram Endcap 1
Urethane bumper 1
-010 quad-ring 1
Ram Bushing 1
-010 o-ring 1 ORU010-0000
Ram Shaft 1
-010 quad-ring 1
Urethane bumper 1
Ram tube 1
-015 o-ring 5 ORU015-0000
Ram Retaining Pin 1
2004 EXCALIBUR® Ram
2000-2003 EXCALIBUR RAM.
Removal of Pneumatic Cyclinder (ie: the
Ram):
De-gas the marker and remove all paint.
Remove the bolt, the body endcap, and
pneumatics regulator. Then remove the ram
retaining pin that holds the ram in place.
Using a plastic dowel rod, gently push the ram
out through the back of the marker body.
Disassembly.
Insert a 1/4" dia metal rod in the setscrew pin
hole. You may have to polish the 1/4" rod just
a little to get it to fit properly. Then, using an
adjustable wrench, unscrew the front nose
from the ram tube by using the 1/4" dia rod to
turn the ram tube. Pull the two halves apart.
You can now replace most of the O-rings and
U-cups if need be. Reassemble in reverse
and tighten down gently. You must use a small
drop of BLUE Loctite on the threads to keep
everything tight. When you re-install the ram it
is a must that you use BLUE Loctite on the
ram retaining pin threads to keep it from
coming loose when the gun is in use. Do not
over-tighten the ram retaining pin.
Troubleshooting:
Air leaking from solenoid:
1. Check the solenoid valve, it may need to be
replaced.
2. Check the ram piston o-ring. Air may be
leaking around it. If air is leaking around it,
replace the ram piston o-ring.
2000-2003 EXCALIBUR Ram Parts:
Part Description: Qty: Part Number:
Ram tube 1
-015 o-ring 5 ORU015-0000
Ram Shaft 1
Urethane bumper 1
-010 o-ring 1 ORU010-0000
Ram Plate 1
Ram Encap 1
-015 o-ring 1 ORU015-0000
7/16x.093 u-cup 1
-010 o-ring 1 ORU010-0000
-013 o-ring 1 ORB013-0000
Urethane bumper 1
H-bar 1
Ram Retaining Pin 1
2001-2003 EXCALIBUR® Ram