User's Manual

K. SOLENOID VALVES.
2004 EXCALIBUR® and VIKING™
SOLENOID VALVES.
Removal of the solenoid valves:
Remove the grip frame and grip plate as one
piece. Carefully pull the grip and grip plate
straight away from the body. The grip plate
locates on two pins in the marker body.
Carefully unplug the solenoid valves from the
circuit board. Using an allen wrench, remove
the screws holding solenoid valve you want to
replace. Lift the valve and manifold straight
out of the marker body. Be careful not to lose
the small o-rings that seal the solenoid to the
body.
Place the o-rings back into the o-ring grooves
on the body. Place the correct solenoid valve
on the solenoid valve mounting bosses and
tighten down screws. The hammer solenoid
valve cannot be installed in the bolt socket
and the bolt solenoid valve cannot be
installed in the hammer socket. Do not over
tighten the screws.
Plug the solenoid valve back into the circuit
board and gently put the grip frame back onto
the marker making sure not to pinch any
wires. Re-install the grip frame screws.
Do not try to work on the solenoid valves. Do
not try to exchange parts from one solenoid to
another. The parts on the solenoid valves are
matched to each other when they are
assembled at the factory and can not be
mixed with other valves. If the solenoid valves
parts are mixed they may not work properly.
Troubleshooting:
Air leaking from the solenoid valve:
1. Check the o-rings sealing the valve to the
body.
2. Check to see if the air is leaking through
the solenoid valve. If air is leaking through the
valve, replace the valve or check the o-rings of
the hammer or ram.
L. SCREWS & O-RINGS
There are various screws and o-rings used in
the EXCALIBUR®, VIKING™,
SIDEWINDER® and SCM™ this list is for
reference. If you are unsure which
o-ring or screw to use check with a certified
airsmith.
SIDEWINDER® O-rings:
-008 o-ring
-010 o-ring
-015 o-ring
-017 o-ring
-113 o-ring
SCM™ O-rings:
-003 o-ring
-008 o-ring
-014 o-ring
-015 o-ring
2004 EXCALIBUR® and VIKING™ O-
rings.
Serial # 1500+
3.3x1.0mm o-ring
-008 o-ring
-010 o-ring
-010 quad ring
-015 o-ring