User Manual

109
Reverb Out Gate
This is a hall reverb that has an additional control. The reverb effect is cut off when the output
drops below the level set in the OutGate parameter.
Parameter Value Range Default Value Q-Link No.
Wet/Dry 0 (DRY) – 100 (WET) 50 Q9
Pre-Delay 1 – 100 50 Q10
Early Reflection 0 – 100 50 Q11
Density 0 – 100 50 Q12
Diffuse 0 – 100 50 Q5
Decay 0 – 100 75 Q6
Lo-Cut 0 – 100 10 Q7
Hi-Cut 0 – 100 10 Q8
Gate Out 0 – 100 0 Q1
Decimator
A Decimator downsamples the incoming signal by removing bits from the digital signal. The
difference between decimation and resampling is that the decimator does not use any filtering to
mask or correct digital artifacts. The result is an effect ranging from mild to almost completely pure
digital distortion, depending on the setting and the source material.
Parameter Value Range Default Value Q-Link No.
Wet/Dry 0 (DRY) - 100 (WET) 100 (WET) Q9
Decimate 0 - 100 0 Q10
Bit Reducer 4 - 32 32 Q11
Resampler
The Resampler is similar to the decimator in that it removes bits from an incoming signal. The
difference is that the Resampler applies a complex suite of filters and anti-aliasing to attempt to
retain the original sound quality. This is a method used by popular vintage samplers and sampling
drum machines from the 1980s. The Resampler effect can be used to achieve a "dirty" sound on
drum loops, without the harshness of distortion.
Parameter Value Range Default Value Q-Link No.
Wet/Dry 0 (DRY) - 100 (WET) 100 (WET) Q9
Rate 0 - 100 0 Q10
Decimate 0 - 100 0 Q11