User Guide

8
PRECAUTION
- Disconnect the power cord from the power socket before any connection.
- The digital optical connection is less sensitive to external disturbance
- Loose connect may create noise when operating
-
The single small number in bracket is the key no. on back panel
CONNECTION TO AC POWER SUPPLY
- Connect the power cord to the AC main socket.
- The receiver is switched on and off by the POWER ON/OFF button (Front Panel label 1).
- Press STANDBY on the (Front panel label 3) or (Remote label 1) to switch on the unit.
CONNECTION TO ANTENNA
- Insert the AM antenna loop into the AM Loop Socket (Back Panel label 3)
CONNECTION TO ANALOG AUDIO / VIDEO
- You can connect the L & R output (except Tape Rec) of the following external player to the
ANALOGUE
AUDIO IN (Back Panel label 4) with a RCA cable:
PHONO (FOR TURN TABLE)
VIDEO (FOR CDV OR LD PLAYER)
DVD (Refer to the DVD connection above)
COMPACT DISC PLAYER (FOR CD PLAYER)
A
UX
(F
OR ANY EXTERNAL PLAY ER WITH
A
NALOG
A
UDIO
O
UTPUT
)
TAPE PLAY (FOR CASSETTE PLAYER)
TAPE REC (FOR CASSETTE RECORDING. CONNECT THE TAPE REC OUTPUT TERMINALS TO THE LINE IN
TERMINALS ON THE CASSESSTE DECK USING THE RCA CORD.)
* Upon connection, you should choose the external sources on the corresponding buttons on front panel
CONNECTION TO DIGITAL AUDIO
- Connect the OPTICAL IN (Back Panel label 8) or COAXIAL IN (Back Panel label 7) of this unit to the digital
output of your external player.
- Digital input signal can only be recognized when DVD, CD or VIDEO 1/2 is the input source.
- Use 75 ohm cable pin cords (sold separately) for coaxial connections
- Use optical cables (sold separately) for optical connections. (Remove the cap before connecting)
* At any one time, only two digital input signals can go into the machine (i.e. via Optical and/or Coaxial
IN)
CONNECTION TO EXTERNAL UNIT WITH 6 CHANNELS
- Left, Right, Central, L Surround, R Surround & the Sub-Woofer signal output of your external decoder with
6-channel output to the 6 CH EXT IN (Back Panel label 1)
CONNECITON TO TV AND VIDEO
- Connect the MONITOR OUT at VIDEO (Back Panel label 9) with a video cord or connect MONITOR OUT at
S-VIDEO (Back Panel label 5) with a S-video cord to the TV VIDEO IN of your TV set
- Connect the VIDEO 1 IN VIDEO IN (Back Panel label 9) / VIDEO 1 IN at S-VIDEO IN (Back Panel label 5) or
VIDEO 2 IN (Front Panel label 32) to the video output of your external players.
CONNECTION