Operation Manual

-15-
-14-
PREPARATION FOR USE
Unpacking and Setup
* Carefully remove the unit from the display carton and remove all packing material from the unit itself.
* Remove any descriptive labels that may be found on either the front or top cabinet of the unit. Do not
remove any labels located on either the back or button cabinet of the unit.
* The detachable AC power cord is packed in the carton separately from the unit. Make sure that the
AC power cord is not accidentally discarded with the carton or packing material.
* Press the CD door OPEN Button to open the CD compartment door. There is a white card in the CD
compartment which is intended to prevent the CD pickup from moving during shipment of the product,
Remove this card from the CD compartment before use.
Battery Operation
The battery compartment is located on the back of the cabinet.
* Remove the battery compartment door by pressing downward on the tabs as shown in figure 1 below.
* Insert 8 C size (UM-2) batteries into the battery compartment as shown in figure 2 below. Be sure to
observe the polarity markings which are engraved inside the battery compartment. If the batteries are
inserted incorrectly, the unit will not operated.
* Replace the battery compartment door.
NOTE: The AC power cord must be disconnected from the AC socket on the back of the unit in order
for the unit to operate on battery power.
Follow these precautions when using batteries in this device.
1. Use only the size and type of batteries specified .
2. Be sure to follow the correct polarity when installing the batteries as indicated in the battery
compartment. Reversed batteries may cause damage to the device.
3. Do not mix different types of batteries together (e.g. Alkaline and Carbon-zinc) or old batteries
with fresh ones.
4. If the device is not to be used for a long period of time, remove the batteries to prevent damage
or injury from possible battery leakage.
5. Do not try to recharge batteries not intended to be recharged, they can overheat and rupture.
(Follow battery manufacturer s directions.)
,
,
1.5V
1.5V
1.5V
1.5V
BATTERY PRECAUTIONS
,
1.5V
1.5V
1.5V
1.5V
8 x R14 C C ELL UM-2
ENGLISH
P
H
O
N
E
S
A
U
X
1.IPOD DOOR
2. REPEAT/ RANDOM BUTTON
3.NEXT BUTTON
4.PLAY/PAUSE/USB BUTTON
5.BASS BUTTON
6.VOLUME BUTTON
7.TUNING CONTROL
8.POWER BUTTON
9.CD DOOR
10.IPOD JACK
11.PROGRAM BUTTON
12.FUNCTION SELECT
13.BACK BUTTON
14.LCD DISPLAY
15.STOP BUTTON
16.USB JACK
17.STANDBY INDICATOR
18.AUX INDICATOR
19.FM STEREO INDICATOR
20.BAND SELECTR(AM.FM.FM ST.)
21.AUX JACK
22.STEREO HEADPHONE JACK
23.AC MAINS
24.FM ANTENNA
25.BATTERY DOOR
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
ENGLISH
Using AC Power
1.Check if the power voltage,as shown on the type plate located on the bottom of the set,
corresponds to your local AC power supply.If it does not,consult your dealer or service
centre.
2.Connect the power cord to the AC MAINS inlet and the wall outlet.The power supply
is now connected and ready for use.
3.To switch off completely,unplug the power cord from the wall outlet.
• Unplug the power cord from the wall outlet to protect your set during heavy thunderstorms.