Operator’s manual www.akai.
TABLE OF CONTENTS 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11.
DISP COMPACT DIGITAL AUDIO TRACK/TUNE LOCATIONS OF CONTROLS 1 2 3 17 15 8 MU 6 7 16 27 PTY TA COMPACT AF DISP DIGITAL AUDIO TRACK/TUNE 13 9 12 10 19 20 21 22 23 24 11 MU 14 18 5 26 4 (1-6) 1. POWER ON / OFF ( ) 2. FUNCTION SELECT BUTTON: BASS / TREBLE / BALANCE / FADER / TA SEEK / MASK DPI / RETUNE / AUDIO DSP / LOUDNESS / ESP / CD MULTI / BEEP / SEEK / STEREO / LOCAL (SEL) 3. VOL UP / VOL DOWN FOR BASS / TREBLE / BALANCE / FADER 4. PRESET STATIONS (1,2,3,4,5,6) 5.
INSTALLATION PRECAUTIONS • Choose the mounting location carefully so that the unit will not interfere with the normal driving functions of the driver. • Avoid installing the unit where it would be subject to high temperatures, such as from direct sunlight or hot air from the heater, or where it would be subject to dust, dirt or excessive vibration. • Use only the supplied mounting hardware for a safe and secure installation. • Be sure to remove the front panel before installing the unit.
Detaching and attaching the front panel The front panel of this unit can be detached in order to prevent the unit from being stolen. DETACHING THE FRONT PANEL B Before detachingA the front panel, be sure to press the PWR button OFF first. Pull out the panel towards you in order to detach completely the panel from the main unit. Refer to instruction. ATTACHING THE FRONT PANEL Make sure the front panel is the right way up when attaching it to the unit as it cannot be attached upside down.
ISO CONNECTOR RCA Jack Line Out: White (left) Red (right) RCA Jack Line In: White (left) Red (right) Tele Mute: (Black) The Tele Mute wire is installed between the mobile car kit adapter and the stereo system. Upon receiving a call the stereo system is automatically muted. When the call is terminated the sound will return through the car audio system. CONNECTOR A 4. MEMORY +12V 5. AUTO ANTENNA OUTPUT 7. +12V (TO IGNITION KEY) 8. GROUND Note: (connector A no.
OPERATING INSTRUCTIONS 1. POWER ON/OFF By pressing this key, the unit is switched on or off. This unit is turned on by pressing any key. 2. SELECT 3. VOLUME UP/DOWN Turning the VOL knob Right or Left (3), you can adjust VOL/BASS/TREB/BAL/FAD. To select other functions, press the SEL (2) button shortly until the desired functions is shown on the display. Figure 1 shows how control functions are selected using the SEL button. 1 2 2 3 4 2 2 5 6 2 Fig. 1 Selection of sound control functions 1.
SEL SEL TA SEEK SEEK TA 2SEL sec. sec. 22SEL sec. TA SEEK 2 sec. TA SEEK TA SEEK SEEK TA SEL SEL 2 sec. TA SEEK SEL 2 sec. 2 VOL sec.
2 sec. SEL SEL SEL SEL LOUD TA SEEK MULTI SEL SEL ESP MASK DPI RETUNE SEL BEEP SEL DSP SEEK SEL / SEEK 2 STEREO/MONO (2)SELSEEK1 ESP MULTI BEEP SEL SEL SEL LOUD When press the SEL button for more than 2 seconds, it is activated as selecting mode of these function. VOL 2 sec. SEL SEL SEEK TA SEEK SEL SEL 2 sec.
6. ‘TA’ function (TRAFFIC ANNOUNCEMENT) When pressed short, it is activated as TA mode on or off When TA mode is on and traffic announcement is transmitted – When the unit is it CD/MP3 mode, it will switch to radiomode temporarily. – If the volume level was under the threshold point, it will be raised to the threshold point. – When TP station is received, TP segment is turned on in LCD display. 7.
CD CONTROL LOCATION OF PARTS TRACK/SEARCH BUTTON (11) FORWARD AND REVERSE TRACK SEARCH (or changing songs) Press the SKIP button ( or ) during play to go to the desired track(song). ....REVERSE ....FORWARD Press and hold the SKIP button ( or ) during play to scan the disc at high speed. When the desired music section of the disc is found, release the button. Normal play will resume. 17. CD SLOT 18. CD EJECT BUTTON Press the EJECT button to remove the CD. 19.
HOW TO SELECT MP3 FILES 1. Searching Track: • Press “A/PS”, then searching track is activated. • Press “SEL”, then the first digit is blinking. VOL VOL / VOL VOL ” knob, VOL • With “VOL select first digit you want. • Press “SEL”, then the first digit is fixed and second digit is blinking. VOL VOL / VOL VOL ” knob, VOL • With “VOL select 2’nd 3’rd respectively. • Then automatically the song you selected will start. 2. Searching File Name: • Press “A/PS” twice, then file search is activated.
TECHNICAL INFORMATION CD/MP3 PLAYER SECTION Signal to noise ratio Channel separation Frequency response > 60 dB > 50 dB (1kHz) 20Hz - 20 kHz TUNER (FM) Frequency range Sensitivity Stereo separation Signal to noise ratio Channel step Intermediate frequency 87.5 -108 MHz 2.8 µV 30 dB 50 dB 50 kHz 10.7 MHz LINE-OUT Output Impedance 350 mV 10k Ohm GENERAL Power supply Power consumption Standby power consumption Speaker impedance Output power 12V DC (10.8-15.
