Operator’s manual www.akai.
TABLE OF CONTENTS 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12.
LOCATIONS OF CONTROLS 10 1 2 3 16 11 7 10 5 1 17 9 2 28 3 16 DISP DISP 13 31 14 20 21 22 23 24 25 6 32 12 4 (1-6) 8 13 29 31 14 27 20 21 22 23 2 4 (1-6) 10 ( 1 ) 2 3 16 11 7 5 17 9 28 POWER ON / OFF 1 31 3 30 FUNCTION SELECT BUTTON: BASS / TREBLE / BALANCE / 1 31 3 30 DISP FADER / ADJ / TA VOL / EON / DSP 3. VOL UP / VOL DOWN FOR BASS / TREBLE / BALANCE / FADER 11 4. PRESET STATIONS (1,2,3,4,5,6) 9 5. ‘AF’ 11 function (ALTERNATIVE FREQUENCIES) 21 6.
INSTALLATION PRECAUTIONS • Choose the mounting location carefully so that the unit will not interfere with the normal driving functions of the driver. • Avoid installing the unit where it would be subject to high temperatures, such as from direct sunlight or hot air from the heater, or where it would be subject to dust, dirt or excessive vibration. • Use only the supplied mounting hardware for a safe and secure installation. • Be sure to remove the front panel before installing the unit.
Notes: • Do not press the front panel hard against the unit when attaching it. It can be easily attached by pressing it lightly against the unit. • When you carry the front panel with you, put it in the supplied front panel case. • Do not press hard or give excessive pressure to the display window of the front panel when attaching it to the unit. CLEANING THE CONNECTOR The unit may not function properly if the connectors between the unit and the front panel are contaminated with dirt.
Press and hold VOL knob to adjust INIT VOL /ADJ/TA VOL/EON ON/DSP Can adjust Initial Volume level using this mode. IN VOL: ADJ: Can adjust clock time. Turn VOL knob clockwise to set hours and counter clockwise to set minutes. TA VOL: Can adjust TA Volume (The volume level when Traffic announcement is transmitted). EON: Can selected EON condition, ON or OFF. DSP: Can select DSP mode (Classic, Rock, POP, Flat) 4. PRESET STATIONS (1,2,3,4,5,6) When pressed short, these keys select a preset station directly.
15. EQUALIZER (DSP) Press DSP to select between (Classic, Rock, POP, Flat) equalizer modes. 16. LCD DISPLAY The Liquid Crystal Display will display the current state of the unit. 17. OPEN FRONT PANEL BUTTON Press button and the front panel will be open. CD/MP3/WMA CONTROL LOCATION OF PARTS TRACK/SEARCH BUTTON (11) FORWARD AND REVERSE TRACK SEARCH (or changing songs) or ) during play to go to the desired track(song). Press the SKIP button ( ....REVERSE ....
HOW TO USE BLUETOOTH IN YOUR CAR AUDIO How to Perform Pairing Before you can dial out from the car stereo, you must first perform PAIRING. Pairing is a procedure used to connect 2 Bluetooth devices together. 1. This unit’s Bluetooth function is always on, perform the pairing starting from your cellular phone. Refer to your cellular manual on proper pairing. 2. Perform the search for available Bluetooth devices, “CAR--BT” will show. Enter ‘0000’ when asking for code. 3.