Operation Manual

RGB: Set the video output to SCART output. If you select SCART connection, you
should set up the play mode as RGB state, then it will output normally.
8.3 AUDIO SETUP
Select Audio in the setup menu, and display the Audio submenu.
8.3.1 Digital output
Selecting the Digital Output setting allows the user to adjust the audio output on S/PDIF
ports to work in harmony with the audio
equipment (e.g. receiver, speakers) connected to
the player.
Off: Digital audio output is disabled.
PCM: Select this option when you are going to use stereo signals (2 channels). You should
combine this option with the option "Lower sampling rate," which we explain further
on
All: If you select this option the player will use the DVD's original audio track. Use this
option when you want to use the Dolby Digital AC3 signals through the optical or
coaxial audio output.
8.3.2 Night Mode
To adjust the linear compression ratio, select to ON when playing a disc in the day so as to
get better acoustical effect; while at night, you can select to OFF.
8.3.3 Down Sampling
Use the down sampling option when you have selected the “PCM” option in the type of
digital audio output:
- ON: Use this option to lower the audio sampling rate.
- OFF: Use this option to deactivate the lowering of the audio sampling rate.
Note: A certain sampling rate is used to record disks (measured in kHz); the higher this
sampling rate, the better the sound quality. If you turn it off, make sure that the amplifier that
you are using is compatible with 96kHz digital signals.
GB-20