Operating instructions

DISC ERRORS
• This compact disc player has built-in error compensation circuits to correct for minor defects
in a disc. There are limits, however, to the amount of correction available.
• In some cases, the CD player may skip some tracks, or parts of tracks, on a disc during disc
play. This problem may be caused by defects (such as scratches) in the disc being played,
which are too large for the error compensation circuits to handle. If you encounter this
problem, check the CD player’s operation as follows, before having the until serviced:
 Play a new disc. If the CD player operates normally, the skipping problem is probably due to
a defective disc.
TO STOP A CD BEFORE THE DISC ENDS CD/MP3 (USB.FLASH CARD)
1. Press the Stop button. Disc play will stop, and the display will show the total number of
tracks.
2. To temporarily stop disc play (Pause mode), press the PLAY/PAUSE button. Disc play will
stop at the current play position. The display will flash.
3. To resume disc play, press the PLAY/PAUSE button again.
TRACK SKIP CD/MP3 (USB.FLASH CARD)
Starting disc play from the beginning of a particular track.
Press the Forward or Reverse Skip Track buttons to select the desired track. The
number of the selected track will be shown on the CD display. Press the PLAY/PAUSE button
to start play.
To skip the next track.
For example, to skip ahead to the beginning of track 5 while track 4 is playing.
1. Press the Forward Skip track button once. Disc play will resume at the beginning of
track 5.
2. The CD player will skip ahead to the next track each time the Forward Skip track button
is pressed. Repeatedly pressing the Forward Skip track button makes the CD player
skip ahead through the disc track by track. Once the beginning of the last track is reached
the CD player advance to the first track.
GB 65 GB 68
13. 14.
Do not burn your disc into different sessions. Files from the second session will not be played. It
is highly recommended that you create your CD by writing only once.
CD-R/CD-RW PLAYBACK
This unit can play CD-RW/MP3 disc
NOTE:
“CD-R/CD-RW play capability of this unit may vary depend on quality of media, CD burner and
application software”.
Playback of MP3 CD-R and CD-RW may depand on recording conditions.
LISTENING TO A CD/MP3(USB, Flash Card)
Normal Playback
1. Press the POWER button to turn the unit “ON”. The POWER indicator light “OFF” and the
LCD backlights “ON”.
2. Select the CD function by pressing the function.
3. Open the CD Compartment Door and place a CD/MP3 on the center spindle with the printed
label side facing ‘up’.
4.Close the CD door. The disc will spin momentarily and “CD READ” will appear in the
display. Then the disc will stop spinning and the display will show the total tracks on the disc.
5.Press the PLAY/PAUSE button. Disc play will begin from the start of the first track of the
disc.
6.As each track on the CD disc is played, show in the display.
7.A particular track can be selected using either of the CD Skip / buttons. If this is done
before pressing the PLAY/PAUSE button, disc play will start with the selected track when
the PLAY/PAUSE button is pressed.
8.At the end of the disc, the unit will switch to stop mode.
NOTES:
• If the disc is deeply scratched, or too dirty, disc play may not start.
• If the disc is inserted incorrectly, or the disc is damaged the “no disc” indicator will appear on
display.