User Guide

Connecting to a monaural TV set
Connecting to a stereo TV set with S-VHS input
Basic Connection
• This player must be connected to a PAL TV or NTSC TV with A/V inlets.
• Ensure that this player and other equipment to be connected are set to the standby mode or off and
disconnect the AC power cords before commencing connection.
• Do not block ventilation holes of any of the equipment and arrange them so that air can circulate freely.
• Read through the instructions before connecting other equipment.
• Ensure that you observe the color coding when connecting audio and video cables.
Note:
• During DVD play, the TV volume may be at a lower level than during TV broadcasts, etc. If this is the case,
adjust the volume to the desired level.
• If the DVD/VCD/CD player is connected to the TV through a video cassette recorder, the picture may not be
played back normally with some DVDs. If this is the case, do not connect the player via the VCR.
TV set
To S-video input connector
Video/audio cable
S-Video cable
To power outlet
(AC 110-240 V,
50/60 Hz)
Ac power
cord
DVD/VCD/
CD/MP3
player
To audio input connector
To video input connector
Audio cable
DVD/VCD/
CD/MP3
player
TV set
Video/audio cable
S-video output connectors
The S (separate) video output connector separates the color (C) and luminance (Y) signals before transmitting them to
the TV set in order to achieve a sharper picture.
Use the S-video cable when connecting the player to a TV set equipped with an S-Video input connector for the best
picture clarity possible.
5
To Video input connector (yellow)
To audio input connectors (red,white)