User Guide

E - 39
• Check that the AC power cord is connected.
• The region number of the disc doesn't match the region number of this Unit.
• The TV is not set to receive DVD signal output.
• The video cable is not connected.
• The TV is not turned on.
• Clean the disc.
• If video from your system has to go through your VCR to get to your TV, the copy-protection applied
to some DVD programs could affect picture quality. If you still experience problems after checking
your connections, please try connecting your Unit directly to your TV through the S-Video-input, if
your TV is equipped with this input.
• The disc is scratched.
• The DVD unit may be set to progressive scan, moreover, TV does not support Progressive Scan
component video signal. Press the P. SCAN button repeatedly until the "CVBS" display. Display may
failed to show "CVBS" in case there is no disc or tray opened.
• The location and orientation of the antenna are incorrect. If you use an indoor antenna, change to an
outdoor antenna.
• The TV antenna wire is too close to the Unit. Separate the antenna wire of the TV set from the Unit.
• Check that the speakers and equipment are connected securely.
• Make sure that you've selected the corrected equipment on the system.
• The system is in pause mode or in Slow-motion Play mode. Press the PLAY button to return to
normal play mode.
• Fast forward or fast reverse is performed. Press the PLAY button to return to normal play mode.
• Check the speaker settings.
• Make sure that AUDIO output and AV IN input connections correct.
• Adjust the speakers volume.
• The DTS DVD disc cannot be decoded to have speaker output.
• This Unit is too hot, shut off half 30 minutes for cool down.
• You can use the Pink Noise setting to test that the speaker output is present (Please see Customizing
the Function Settings)
• Check that the speakers and equipment are connected securely.
• Check that the connecting cords are away from a transformer or motor, and at least 10 feet (3
meters) away from a TV set or fluorescent light.
• Move your TV away from the audio equipment.
• The plugs and jacks are dirty. Wipe them with a cloth slightly moistened with alcohol.
• Clean the disc.
• Vibrations from the speakers are affecting the Unit.
• Remove any obstacles between the remote and the Unit.
• Use the remote near the Unit.
• Point the remote at the remote sensor on the Unit.
• Replace all the batteries in the remote with new ones.
• There is no disc inside ("No Disc" appears on the TV screen).
• Insert the disc correctly with the playback side facing down on the disc tray.
• Clean the disc.
• A non-NTSC or PAL disc has been inserted. The Unit and disc region numbers are incompatible.
Press the NTSC/PAL button on the remote to output the video signal.
• Condensation may have formed inside the Unit due to a sudden change in temperature. Wait about
an hour for it to clear and try again.
• Reset the Unit, press the STANDBY/ON button to turn off the Unit, wait for a few seconds, then
restart the Unit.
• Aim the aerial for best reception :
FM : unwire the FM antenna wire.
AM : Rotate the AM(MW) loop antenna
• Keep the unit away from electrical equipment.
No power.
No picture.
The picture is not
clear.
Trouble Shooting Guide
No sound or only a
very low-level sound
is heard.
The remote does not
function.
The disc does not
play.
Severe hum or noise
is heard.
The DVD door cannot
open.
If a fault occurs, first check the ponts listed below before taking the set for repair. If you are unbale to remedy a problem by
following these hints, consult your dealer or service centre.
WARNING: Under no circumstances should you try to repair the set yourself, as this would invalidate the guarantee.
SYMPTOM CAUSE (AND REMEDY)
Poor radio reception