User Guide

10 EWI4000s Manual Addendum v2.3
SETTING PITCH BEND DOWN:
Press the [SETUP] button.
Use the [HOLD] and [OCT] buttons to select “Pd” (Pitch Bend Down) menu shown on
the program/data display.
After selecting “Pd”, release the [SETUP] button.
You can now scroll through and select different Pitch Bend Down options using the
[HOLD] and [OCT] buttons to move through the menu.
PITCH BEND DOWN OPTIONS:
>
For more information see “Adjusting the Bend Effect” section of the Operator’s
Manual (page 16).
Pb – (pitch bend) – Default ENABLED
While in “Pd”, this option will enable and disable the transmission of MIDI
pitch bend messages. If this is disabled, the pitch bend down sensor will not
transmit MIDI pitch bend information if you use it while you are playing.
1. Press the [TRANS] button to enable bend down control from the Bend
up/down plate. You will see a small dot light up between the “P” and
“b” to show that it is enabled. Press the [TRANS] button again to
disable it.
CC – (control change) – Default CC #49 DISABLED
Select this option if you would like the pitch bend down sensor to transmit
MIDI continuous controller (CC) information.
1. While ‘CC’ is selected, press the [TRANS] button to enable the
transmission of MIDI CC data. You will see a small dot light up
between the “C” and “C” to show that it is enabled. Pressing the
[TRANS] button again will disable it.
2. Press and hold the [TRANS] button to view the MIDI CC number
which the bend up control will transmit.
3. While pressing the [TRANS] button, you can use the [HOLD] and
[OCT] buttons to increment and decrement the CC number.