Service manual

SERVICE MANUAL

! Installation - MPC4000

1. Remove the fixing screws of the MPC4000 Side Panels (4pcs. on each side) and remove Side Panels. Next,

remove the screws (5pcs. on each side) hidden by the Side Panels and then remove the center screws (2pcs.)

located underneath the Armrest and the to pmost of Rear Panel. The Top Panel Block can be swing-opened by

lifting the Armrest from the front. Save the removed screws.

2. Remove the fixing screws (2pcs.) for the Mask Plate on the Rear Panel and remove the Mask Plate. Save the

screws for later use. The Mask Plate is not used.

3. Referring to the illustration, set the IB-4D on the Rear Panel and Mounting Post and fix it securely with the screws

removed in earlier step and the Fixing Screw included.

4. Connect the cable from IB-4D board to the connector (P3) on the I/O board.

5. Replace and fix the Top Panel Block and Side Panels in the opposite order to which they were removed.

✽ Be sure to fix the screws and connectors securely to avoid malfunctioning.

IB-4D

PC IO

MPC4000