User Guide

Chapter 11—Using Q-LINK
100
The knobs and sliders have separate pages. As necessary, move between these pages by pressing the [F1]
key (to set knobs) or the [F2] key (to set sliders).
A Multi field: Selects the multi for which you want to make Q-LINK settings.
B PART/FX field: When you operate a knob/slider, this setting specifies whether the program assigned to
a part of the multi will be controlled (PART) or an effect parameter will be controlled (FX). The select-
able content of the field at the right will depend on whether you choose PART or FX.
C Assign field: Selects the type of parameter that will be controlled by the knob or slider. If you selected
PART in (2), you can select program parameters. If you selected FX, you can select effect parameters.
D Type field: Selects how the value will change when you operate the knob or slider.
E Range field: Specifies the amount of change that will occur when you operate the knob or slider.
F [F1] key (KNOB): Accesses the Q-LINK setup knob page.
G [F2] key (SLIDER): Accesses the Q-LINK setup slider page.
2. Move the cursor to the Multi field, and turn the [JOG] dial to select the multi for which you
want to make settings.
Q-LINK settings are stored as part of the multi. Thus, you must first use the Multi field to select the multi
for which you want to make settings.
3. Move the cursor to the Part/FX field for the knob or slider whose settings you want to make, and
turn the [JOG] dial to specify whether you will control a part (PART) or an effect (FX).
4. Press the right cursor key, and select a part number if you selected PART, or an effect number if
you selected FX.
5. Move the cursor to the Assign field, and select the parameter that you want to control from the
knob or slider.
The parameters that can be selected will depend on whether you have selected PART or FX.
If you selected PARTYou can select any parameter that is available as a program modulation destination.
If you selected FXYou can select effect parameters of the corresponding effect.
6. Move the cursor to the Type field, and turn the [JOG] dial to select one of the following two
ways in which the value will be controlled.
OFFSET
The value will be adjusted in the positive or negative direction, relative to the existing setting of the param-
eter.
The 12 o’clock position in the case of a knob, or the center position in the case of a slider, will correspond
to the existing setting of the parameter.
REPLACE
The value will change according to the movement of the knob or slider, regardless of the existing setting of
the parameter.
1
2
4
3
5
67
1
2
3
4
5
67
In the case of REPLACE
Existing value
Turn toward the right to
adjust the value positively
Turn toward the left to
adjust the value negatively
In the case of OFFSET
The value will change from
minimum to maximum,
regardless of the existing value