User Guide
Using Q-LINK sequence
101
7. Move the cursor to the Range field, and turn the [JOG] dial to set the amount of change that can
occur.
The Range field specifies the minimum and maximum values that can be controlled by the knob or slider. If
the Type field is set to OFFSET, you can adjust this in a range of -50–0–50. If it is set to REPLACE, the
range will be 0–100.
8. When you have finished making settings, save the multi as necessary.
When you turn the ACTIVE key of a knob/slider on (LED lit) and operate that knob/slider, the sound will
change according to the Q-LINK settings you made.
Using Q-LINK sequence
Q-LINK sequence is a function that lets you program knob/slider movements in sixteen steps, and play back
the movements automatically in synchronization with a sequence or song. This lets you create rhythmic
changes in volume that are synchronized to the tempo of a sequence or song, or create rapid tonal changes
that would be impossible to perform manually.
1. Press the Q-LINK section [SEQUENCE] key.
The Q-LINK sequence page will appear. Separate pages are provided for the knobs and the sliders. As nec-
essary, press the [F1] key (for knobs) or [F2] key (for sliders) to switch pages while you make settings.
A Seq (sequence) field: Selects the sequence in which you will register the Q-LINK sequence settings.
B Step field: Specifies the length of each step.
C Setting field: Registers the movements of the knobs or sliders.
D [F1] key (KNOB): Accesses the Q-LINK sequence knob page.
E [F2] key (SLIDER): Accesses the Q-LINK sequence slider page.
F [F3]–[F6] keys (Q1–Q4:ON/OFF): Switches Q-LINK sequence on/off for each knob or slider.
2. Move the cursor to the Seq field, and turn the [JOG] dial to select the sequence for which you
want to make settings.
Q-LINK sequence settings are saved as part of the sequence. The name of the selected sequence will be dis-
played in the Seq field.
Note: If you select OFFSET, moving the knob/slider in the negative direction will have no effect if the existing
setting is zero. Likewise, moving the knob/slider in the positive direction will have no effect if the existing setting
is the maximum.
1
3
2
45
6
1
3
2
4
56