User Guide

Chapter 2—Introducing the MPC4000
16
9. Make sure that the Load field is set to WITH SAMPLES, and press the [F5] key (DO IT button).
The MPC4000 will load the program. If the Load field is set to WITH SAMPLES, the necessary samples
will be loaded into memory along with the program.
The program has now been loaded into memory. In order to play the program, you will need to assign it to
a part.
10. Press the mode section [MAIN] key.
The main page will appear. Here you can create and play sequences.
11. In the Track block located in the middle of the page, make sure that the Out1 field is set to
PART, and the PART field is set to a value of 1.
12. Move the cursor to the right side of the PART field, and turn the [JOG] dial.
The following popup window will appear.
13. Turn the [JOG] dial to select the program, and press the [F6] key (SELECT) to finalize the
program.
The program has now been assigned to part 1. Now you can strike the pads to play the selected program.