User Guide

Editing part parameters
49
Editing part parameters
The following pages explain how to select the program that will be used by each part, and set parameters
such as volume, receive MIDI port and MIDI channel.
Assigning a program to a part
Here’s how you can assign a program from the MPC4000’s internal memory to each part of the currently
selected multi.
1. Press the [MULTI] key, and then press the [F2] key (MIX).
The Mix page will appear. In this page you can edit mix-related parameters for each part.
A Multi field: Indicates the name of the cur-
rently selected multi.
B Part field: Indicates the part number.
C Program/Type field: Selects the program
that will be assigned to that part. The Type
field will show an abbreviation to indicate the
type of program that is selected.
D Lvl field: Adjusts the volume of that part.
E Pan field: Adjusts the pan of that part.
F Out field: Specifies the output jack for the
audio signal of that part.
G FX field: Adjusts the send level to the effect
bus you selected in
8.
H Send field: Selects the effect bus that will be used by that part.
I [F5] key (MUTE): Mutes the part that is currently selected by the cursor.
J [F6] key (SOLO): Solos the part that is currently selected by the cursor (all other parts will be muted).
2. If necessary, move the cursor to the Multi field and turn the [JOG] dial to select a multi.
3. Move the cursor to the Part field, and turn the [JOG] dial to select the part whose parameters
you want to edit.
4. Move the cursor to the Program/Type field of the part to which you want to assign a program,
and turn the [JOG] dial to assign the desired program.
The program Type area at the right of the program name will show an abbreviation indicating the type of
program you assigned (DR= drum program, KG= key group program).
Adjusting the mix parameters of a part
Here’s how to adjust the mix parameters such as volume, pan, and effect send level for each part.
1. Press the [MULTI] key, and then press the [F2] key (MIX).
2. Move the cursor to the Part field and turn the [JOG] dial to select the part whose settings you
want to adjust.
3. Move the cursor to the field of the parameter you want to adjust, and turn the [JOG] dial to
adjust the value.
Hint: You can also switch multis in the List page ([MULTI] key → [F1] key).
Hint: You can also assign a program in the MIDI page ([MULTI] key
→ [F3] key), Span page ([MULTI] key
→ [F4] key), or Main page ([MAIN] key).
1
2
34
5
67 8
9J