User Guide

Chapter 8—Recording and editing samples

A New name ﬁeld: Displays the name of the

sample. If necessary, you can move the cursor

to this ﬁeld and edit the name.

B [F1] key (RETRY): Discards the edited result,

and returns to the previous page.

C [F2] key (OVER WR): Overwrites the edited

result onto the original sample in memory,

replacing it.

D F3] key (P®ORIGIN): Plays the sample as it

was before editing.

E [F4] key (P®NEW): Plays the edited sample.

F [F5] key (ADD PGM): Accesses the Add to Program popup window, where you can add the edited

sample to a program.

G [F6] key (KEEP): Preserves the edited sample in memory.

6. Use the [F3] key (P

®ORIGIN) and [F4] key (P®NEW) to compare the sample before and after

editing.

7. If you are satisfied with the resampled result, assign a new name to the sample as desired, and

press the [F2] key, [F5] key, or [F6] key to save the new sample.

However if you press the [F2] key (OVER WR), the new sample name will be ignored, and the edited sample

will be overwritten onto the original sample, replacing it.

Using edit commands to edit a sample

Here’s how to use the edit commands of the Sample page to edit a sample.

1. In Sample mode, press the [F5] key (EDIT).

The Sample Edit popup window will appear, where you can edit the sample.

A Edit ﬁeld: Selects an editing command. The

following displays will change according to

the command that you select.

B Section ﬁeld: Selects the region to which the

editing command will apply.

2. Move the cursor to the Edit field, and select a command.

The following illustration shows the screen that will appear if you select the DISCARD command, which

deletes the waveform data that is outside the speciﬁed region. (For details on all the available commands

and the items that you can set, see the reference manual.)

3. Move the cursor to each field, and change the settings as necessary.

If you have selected the DISCARD command, move the cursor to the Section ﬁeld and select one of the fol-

lowing regions.

TRIM.............. Between the start and end points

LOOP ............. Between the loop start and loop end points

REGION......... The region selected in the Region page

If you select TRIM for the DISCARD command, the region between the start and end points will be kept,

and the rest of the waveform data will be deleted.

Note: The Section ﬁeld will be displayed only if you have selected a command that requires you to specify an

region.

234 567