Operation Manual

NAVIGATING EDIT MODE

1. Press [EDIT] to enter Edit Mode.

2. To select the controller you wish to edit, simply engage it – this will

prompt the screen to display the available event types for the

particular controller (Page 1).

3. If there are multiple event types for the selected controller, turn the

[VALUE] dial to select the desired event type. Press [ENTER] to

view the parameters of the selected event type, if available (Page

2).

4. To move between the parameter fields on Page 2, use [<] and [>].

To change the values of the fields, turn the [VALUE] dial.

5. When finished editing the controller, press [ENTER] to accept the

change or press [<] to cancel.

FIELD 1

FIELD 2

FIELD 3

FIELD 4

EDIT MODE

Pressing [EDIT] calls up Edit Mode.

In this mode, you can edit the

settings of the currently selected

Preset. The settings vary

depending on the controller you are

editing and are described below.

Please note that the changes you

make will only apply to the currently

selected Preset.

Also note that if you wish to save

the changes made in Edit Mode,

you will need to save the current

preset.

You can use the example screenshot on the right to

help you determine where the Page 2 parameters

described on the following page will appear on the

screen.