Use and Care Manual

Recirculating Installations & Carbon Filters
Non-Vented (Recirculating) Installations
If it is not possible to vent cooking fumes and vapors to the out-
side, the hood can be used in the non-vented (recirculating ver-
sion, fitting a carbon filter at the motor. Fumes and vapors are
then recycled through the top grille. Do not block the chimney
holes and vents on either side.
Installation Steps for Recirculating
Prerequisites:
 1 set of carbon filters (2 pcs.) [”Recirculating Kit”]
Step 1: Remove the mesh or baffle filters
Step 2: Locate the motor and the carbon filter clips on each side
Step 3: Place the carbon filters into the corresponding ends of the
motor
Step 4: Twist each carbon filter until it clips into place
Carbon Filter Care Guide
Carbon filters have to be replaced approximately every 6 months
depending on the frequency of use. They cannot be washed and
reused. Please replace carbon filters when your kitchen air is no
longer smelling fresh and dispose of the used ones.
DO NOT WASH
DO NOT REUSE
DO NOT OPEN
Ordering Carbon Filters
Carbon filters can be ordered on: ShopRangeHoods.com or by
phone at: [phone]. Please ask for Sales.
 Navigate to Replacement Parts in the navigation bar
 Click Recirculating Kit
 Under Options, click and choose your model number/PID
 Checkout to complete the ordering process