Installation Guide

a) This appliance is designed to be permanently fixed to the wall at a minimum
height of 300mm. A height of 600mm from the bottom of electric fireplace to
the floor is recommended for optimum viewing.
b) Use the mounting bracket as a template and mark the positions on the wall.
Make sure that these holes are leveled.
c) Put the bracket aside and drill holes with a depth of 35mm using an 8mm
drill bit.
d) Clean each hole and insert one wall anchor in each hole. Make sure the
edge is flush with the surface.
e) Hold the bracket in position and secure it with screws.
f) Carefully lift the electric fireplace and hook it to the wall bracket. The rear
mounting bracket lip slots in between the wall mounting bracket and the
wall. Do not let go of the electric fireplace until you are sure it is safely in-
stalled to the mounting bracket.
g) The wall mounting bracket must be fitted horizontally. The power cable
needs to routed to the bottom right of the electric fireplace. See Figure 4, 5,
6
h) Make sure all side vents are exposed and not obstructed in any way.
Installation Instructions & Requirements