Installation Guide

Undermount Kitchen Sink Installation Instruction

This sink is specifically designed to be under-mounted in a solid surface countertop only.

CAUTTION: Sink edge may be sharp; handle with caution. Do not install a damaged sink – inspect

carefully.

1. Cut out countertop using this template.

2. Determine placement of clip brackets as indicated by template. Pre-drill holes according to

method desired based on countertop material.

3. Apply a bead of silicon evenly along edge on underside of countertop.

4. Position and align sink over opening. Press sink onto silicon seal.

5. After re-checking alignment, tighten clip brackets against sink edge.

6. Remove excess silicon

NOTE: THIS TEMPLATE IS ONLY A GUIDE. ACTUAL SINK SHOULD BE PRESENT TO ENSURE PERFECT CUT

OUT.

HINT: After silicon cures, wipe inside edge with denatured alcohol. This will smooth out any rough

areas.

PAGE 1
Undermount Kitchen Sink Installation Instruction This sink is specifically designed to be under-mounted in a solid surface countertop only. CAUTTION: Sink edge may be sharp; handle with caution. Do not install a damaged sink – inspect carefully. 1. Cut out countertop using this template. 2. Determine placement of clip brackets as indicated by template. Pre-drill holes according to method desired based on countertop material. 3. Apply a bead of silicon evenly along edge on underside of countertop. 4.