Owner’s Manual Stainless Steel Range Hood Wall Mounts Only Copyright ShopRangeHoods.com© 2016 Office: +1 (626) 321-9834 Email: support@shoprangehoods.com Distributed by ShopRangeHoods.
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, INJURY TO PERSONS, OBSERVE THE FOLLOWING: 1. Use this unit only in the manner intended by the manufacturer. If you have questions, contact the manufacturer at the address or telephone number listed in the warranty. 2. Before servicing or cleaning unit, switch power off at service panel and lock the service disconnecting means to prevent power from being switched on accidentally.
TOOLS & PARTS REQUIREMENTS LOCATION REQUIREMENTS VENTILATION REQUIREMENTS Electrical drill or ratchet driver 1/2” drill bit for drilling pilot holes 1¼” drill bit for drilling electrical wiring access hole Screwdrivers: Philips & Straight blade Pliers Tape measure or ruler and pencil Electrical supplies for wiring Aluminum foil tape and/or HVAC tape Hammer Jigsaw or saber saw Stud finder PARTS SUPPLIED Body & Main Unit: 1 pc. Chimney Mounting Bracket: 1 pc.
Recirculating Installations & Carbon Filters Non-Vented (Recirculating) Installations Carbon Filter Care Guide Ordering Carbon Filters If it is not possible to vent cooking fumes and vapors to the outside, the hood can be used in the non-vented (recirculating version, fitting a carbon filter at the motor. Fumes and vapors are then recycled through the top grille. Do not block the chimney holes and vents on either side.
Cleaning & Maintenance Cleaning Mesh or Baffle Filters Types of Metal Filters Interior Range Hood Cleaning Mesh and baffle filters can be cleaned with regular household dish washing soap and hot water. Please wear gloves while cleaning filters to protect against scrapes or cuts. Exercise caution around sharp metal edges and corners. Mesh The unit must be turned off before being cleaned. Also avoid spraying cleaner directly onto the light bulb or light bulb socket.
Wall Mount Range Hood Installation Preparing Your Wall / Mounting Information ATTENTION HOMEOWNER: These installation steps are meant to be a general guideline for mounting and installing your wall mount range hood. If you require assistance, please contact your local contractor. Please exercise extreme caution when handling a range hood to prevent risk of injury and electric shock. Building codes will vary.
Wall Mount Range Hood Installation Mounting Information: Hanging the Main Unit ATTTENTION HOMEOWNER: Two people will be required to lift and hang the main unit. We highly recommend professional help and an extra set of hands. Diagram A: Hanging Main Unit KEY A: M5 X45 mounting screws B: Range hood mounting plate and slots 1. Level the range hood and tighten upper two mounting screws (Figure B) 2. Remove the mesh or baffle filters on the bottom of the range hood.
Wall Mount Range Hood Installation Mounting Information: Connect Exhaust Pipe ATTENTION HOMEOWNER: We include a complementary 6” plastic exhaust pipe for ease of installation. Please check your local building codes if another exhaust pipe is required to pass inspection. Diagram C: Air Damper (Preassembled) Diagram D: Attaching Exhaust Pipe KEY A: Air damper B: M5 X 12 screw C: Air flap (NOTE: Remove shipping tape) KEY A: Exhaust pipe B: Air damper 1.
Adjusting the Clock Control Panel: Type A Control Panel: Type B1 Clock Setting: Type A Step 1: Tap and hold for 3 secs. Step 2: Tap repeated to set the hour. Step 3: Tap to switch to mins. Step 4: Tap again repeatedly to set the mins. Step 5: Tap again to finish. Clock Setting: Type B Step 1: Tap and hold for 3 secs. Step 2: Tap OR repeatedly to set the hour. Step 3: Tap OR to switch to mins. Step 4: Tap OR again repeatedly to set the mins. Step 5: Tap again to finish.
Adjusting the Clock Control Panel: Type D Clock Setting: Type D Step 1: Tap and hold Control Panel: Type E for 3 secs. Step 2: Tap OR repeated to set the hour. Step 3: Tap to switch to mins. Step 4: Tap OR Step 5: Tap again to finish. repeatedly to set the mins. Clock Setting: Type E Step 1: Tap and hold Control Panel: Type F for 5 secs. Step 2: Tap Step 3: Tap repeated to set the hour. Step 4: Tap repeatedly to set the mins. Step 5: Tap again to finish.
RETURNS & WARRANTY RETURNS, DAMAGES, MISSING PARTS We thank you for your purchase. If you are not satisfied with your purchase or have an issue with our product, please kindly let us know. Our full returns policy is outlined below. Carefully read over our terms before contacting us. If you have questions, our customer service team can be reached at: +1 (626) 321-9834 or support@shoprangehoods.com.
