Installation Guide

A. Direct Connect Instructions
Step 3
Using a drill, attach the wall mounting brackets with the included
hardware. An extra set of hands may be required for the following
steps. Lift and locate the hot and cold water lines on the shower
panel (red circle).
Step 4
Connect the hot and cold water supply lines to the flexible hoses.
Be sure to use the included washers. It is recommended a ⅜” right
angle connection be installed to better route the flexible hoses
(see diagram).
Step 5
Once connected, lift the entire shower panel and hook it to the wall
using the mounting brackets. There are two types of mounting
brackets used for our shower panels. Check the next page for de-
tailed mounting instructions.
Step 6
Check if the unit is leveled. Test out all shower functions including
the water temperature to finish installation.
NOTE: If you’re water temperature is either too hot or too cold,
please check the hot and cold water lines. The connection may be
reversed (cold to hot).
Step 7
Complete the installation by using silicone sealant around the pe-
rimeter of the shower panel. Your installation is now complete.