Instructions / Assembly

AKDY Under Mount Range Hood Installation
ATTTENTION HOMEOWNER: Two people will be required to lift and install the main
unit. We highly recommend professional help and an extra set of hands.
Measure the distance between the stove top and the bottom of the range hood. A distance
of 27” to 30” is recommended.
Step 1: There are two methods (A or B) to mount this range hood. For PIDs RH0026,
RH0027, and RH0028, installation method A is not compatible with your model.
Method A
Proceed if you would like to mount this range hood without using the hood mounting brack-
et.
1A. Using references in the Location Requirements section, center the hood beneath the
cabinet and flush with the front of the cabinet.
2A. Draw the electrical wires through the cabinet access opening if not done so already.
3A. From inside of the hood, place screws into the exact center of each knockout hole and
secure to cabinet bottom. Finish tightening all screws until secure. Be careful when using
electrical screwdrivers, they may cause damage to the range hood. Skip Method B below
and proceed to step 2.
CAUTION: Make certain the range hood is fully secured before releasing!
Method B
Proceed if you would like to mount this range hood using the provided hood mounting
bracket (If included).
1B. Using references in the Location Requirements section, mark the leveling point of the
hood. Position two mounting screws on the wall, leaving 1/8” space away from the wall.
Mounting the hood on wall studs is highly recommended.
2B. Attach the hood mounting bracket to the back of the hood with four screws as shown in
Figure 3.
3B. Puncture the knockout wire access hole at the back of the hood and draw the electrical
wires.
4B. Align hood-mounting brackets to the screws on the wall and hook hood into place as
shown at the right of this page. Tighten screws to secure hood to the wall.
CAUTION: Make certain the range hood is fully secured before releasing!