Instructions / Assembly

Installation Steps
Prepare Location
 The range hood is to be installed 24" (61.0 cm) min. for electric cooking
surfaces, 27" (68.6 cm) min. for gas cooking surfaces, to a suggested maxi-
mum of 36" (91.4 cm) above the cooking surface.
 Remove film from metal surfaces as needed prior to assembly.
 Check your ceiling height and the range hood height maximum before you
install your hood.
 Always disconnect the power!
 Determine the proper venting method before use: roof venting or non-
vented (recirculating)
Range Hood Mounting Screws Installation
1. Determine and mark the centerline on the ceiling where the range hood will
be installed. Please take note of the requirements for ceiling support structures.
See the “Location Requirements” section. Make sure the range hood is cen-
tered over the cooking surface.
2. Put the wall anchors into each hole and use 4 mounting screws to fix the
plate onto the ceiling.
NOTE: The mounting location should be secured into a ceiling support
structure capable of holding 80 lbs (36.6 kg).
3. Determine the required location for the home power supply cable and drill a
½" (1.3 cm) diameter hole for wire access.
4. For vented installations only: Using a jigsaw or keyhole saw, cut a 6½" (16.5
cm) diameter hole for the vent pipe / duct.
5. Attach the angle iron to the mounting plate with four M5*40 screws, washers,
and nuts on each side.