28",
4 30 14
Range hood body Aluminum Filter LED lamp
Install the exhaust pipe (Buy individually)
Determine and mark the horizontal line and perpendicular line on the base of the cabinet. 10.83" Cut out the opening where the insert will be installed. 26 . 75"/34.
The hood has to be installed inside the cabinet. It should be installed a front and rear stud support. It would be better if there is space enough for installed the left and right support. Rear support Right support 10. 1 . 5" 26. 2" Front support 24" Left support Determine and make all necessary cuts in the wall or ceiling for the ductwork. Install the duct work before installing the insert. In front and rear side have 8 holes, secure the range hood using the 4X30 screws (8 pcs) .
In left and right side have 4 holes, secure the range hood using the 4X30 screws (4 pcs) . Open the filter : Anticlockwise the lock with 90° Installation finished. CAUTION: BEFORE USE Please remove the white/blue protective film on the range hood.
Motor Carbon Filter Fitler Panel
A B D C E
