Installation Sheet
GUIDELINES
FOR UNIT
INSTALLATION
ON WHIRLPOOL EQUIPPED UNIT
!
Check for required modifications to
framing due to whirlpool components.
The unit must be positioned square in
the alcove framework. The use of shim
or filler material behind the fastening
flange at each framing member may be
required to maintain the unit in the
proper position.
After the unit is confirmed level and square in
the alcove, drill a 1/8 inch hole through the
fastening flange at each framing member and
every 8 inches along the front fastening
flanges. Secure the unit in place across the
back wall first, followed by the flanges at each
end and along the front flanges, using 1-1/4
inch long (large headed) nails or other
appropriate fasteners. Continuously check to
confirm the unit remains square within the
alcove as it is being secured. (Figures 3a &
3b)
CAUTION: It is advisable to protect the
unit surface with a thin plywood or
cardboard shield while fastening the
flange to the framing.
Water Supply and Drain Connections
Refer to, and follow, the assembly and
installation instructions provided with the
supply valves and drain system. Carefully
check all fittings and connections for
leaks.
WARNING!
THE UNIT BOTTOM SHOULD BE
CLEAR OF ALL POTENTIALLY
DAMAGING DEBRIS AND THE
SURFACE PROTECTED BEFORE
STEPPING INSIDE.
Finishing Guidelines
Furring strips or filler material may be
required over the framing to ensure the
underlayment will lie flush over the
fastening flanges (Figure 4a).
A water resistant underlayment is
recommended on areas surrounding the
unit. Stop the underlayment 1/16 to 1/8 inch
from the unit surface, and fill the space with
a continuous bead of waterproof sealant.
Carefully fasten the underlayment near the
unit to avoid damaging the unit surface.
Seal the seams and edges of the
underlayment, as required, and install the
finish material to specifications. (Figure 4a)
Page 4
0703 10023045
Wall
Framing
Fastening
Flange
Fi
gure
4
-
W
a
ll
Fi
n
i
s
hi
ng
Furring Strip
or Shim
Material
Waterproof
Sealant
Water Resistant
Underlayment