User's Manual

MICRO RUN
Push in the button for MICRO and the diode lamp for micro lights.
The micro-run movements are only at lowest speed in micro-run
mode irrespective of the compression of the pushbuttons. The
buttons are looped so that only one movement can be operated at a
time. The other functions are working as in ordinary runs.
FLOODLIGHT ⊗
The lights can be operated at any time after switching the Main
contactor ON, Light OFF must be set before Main Contactor OFF.
Otherwise the function remains. A diodlamp indicate that the light is
on.
One extra function and Choice 1 and 2, works only on variant 2.
(See page 3)
EXTRA
Function is obtained immediately when the switch is actuated in
position .
CHOICE 1, 2 or 1+2
Push the button for 1 and/or 2, and the diode lamps indicate the
selection.
MANUAL BC8518 No. 928754-000 USA
Version: A0 Approved by: HH
Page 5 (12)
SIGNAL
A signal can be emitted at any time during the run and is obtained as
long as the push button switch is depressed.
EMERGENCY STOP
Depress the STOP button for Emergency STOP.
TRANSMITTER OFF
MAIN CONTACTOR OFF
Depress the triangular button for about 2 seconds, until the
indication for operation goes out, which switches off the transmitter.
At the same time the Main Contactor in the receiver is deactivated.
AUTOMATIC SWITCH OFF
FUNCTION
The indicator lamp for operation goes out and the Main Contactor is
de-energized. For renewed activation of the Main contactor restart is
required, press the stop button, pull it out again and press the signal
button. Accumulator voltage below 5,7V also causes automatic
switch-off.
MANUAL BC8518 No. 928754-000 USA
Version: A0 Approved by: HH
Page 6 (12)
X
X