User's Manual

TRANSMITTER LED INDICATIONS
If the transmitter under start up or under operating detect a fault in
any self-tests it will indicate with a continuously red light. After that
the transmitter closes down. If it indicates continuously yellow light
when you start up the transmitter, at least one of the pushbuttons is
activated.
INDICATIONS EXPLANATIONS
Green flashing Operating
Yellow flashing Battery voltage low < 6,3 V
Yellow continuously Discharge battery voltage < 5,7 V
Red continuously,
at start
Electronic lock, see the Installation
manual
Red continuously,
at operating
Fault, see the Installation manual
DISCHARGED BATTERY
The transmitter is equipped with an indicator lamp for battery status.
The lamp blinks slowly green when the battery voltage is normal
(7,4V), but starts to blink rapidly yellow, when it falls (6,3V). When
the indicator lamp has started blinking rapidly yellow, the
transmitter can be operated for approx 10 min. before the voltage is
so low (5,7V) that the transmitter switches off automatically. The
indicator lamp showing fixed light indicates this.
MANUAL BC8518 No. 928754-000 USA
Version: A0 Approved by: HH
Page 7 (12)
CHARGING INSTRUCTIONS
The battery has got power for 12 hours continuous operation.
Charging time is 2 hours.
230V AC CHARGING DEVICE
Manufacture ANSMANN
The charging device has a green LED, shows that the charger is
connected to the main, and a red LED who indicates:
Continuously indication Charging
Flashing indication The battery is wrong or not connected
No indication Full charged battery
Manufacture MASCOT
Do not connect the charger to the mains before it is connected to
the battery. The charging device has a LED who indicates:
Orange indication Quick charge
Yellow indication Maintenance charge
Green indication Full charged battery
DC CHARGING DEVICE
The charging device has a fixed GREEN indication for quick.
charge. When the battery is charged the indication switches off.
Still a certain maintenance charge is going on.
NOTE! If the indication not light when the battery is placed in
the charger, the remaining capacity in the battery is to high to
enable quick charge.
Take the battery out of the charger before the main-connection is
disconnected.
MANUAL BC8518 No. 928754-000 USA
Version: A0 Approved by: HH
Page 8 (12)