User's Manual

!
!
9. If you loose control of the crane movements, release the
pushbuttons in order to stop the crane. If still it does not
stop, actuate the STOP function.
10. Find out where the crane's main power disconnection is in
order to be able to quickly switch off if required.
11. Never hand over the transmitter to anybody who has not
undergone training in radio-control crane operation.
12. After completed operation you should always switch the
transmitter off with STOP. Note! Do never put the
transmitter aside without switching the transmitter off with
STOP.
13. The main contactor of the crane is to be switched off after
end of working hours. The transmitter is then to be kept
inaccessible to unauthorized persons.
14. In case of faults or breakdowns in the radiocontrol
equipment the crane should permit operating from the cab
or with suspended operating gear. In such case first turn the
switch from radio operation to manual operation. Make
certain how this switch-over is to be made before you start
driving any individual crane.
15. Make sure that the receiver cannot be activated when you
service the transmitter.
ALWAYS REPORT DEFECTS AND DEFICIENCIES TO
THE WORK MANAGEMENT.
MANUAL BC8518 No. 928754-000 USA
Version: A0 Approved by: HH
Page 11 (12)
FCC Identifier OG4BC8518
This device complies with Part 15 of the FCC rules. Operation is
subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation.
Caution: Any changes or modifications not expressly approved by
the party responsible for compliance could void the user´s authority
to operate tne equipment.
MANUAL BC8518 No. 928754-000 USA
Version: A0 Approved by: HH
Page 12 (12)
!
!
!
!
!