DRIVING INSTRUCTION REMOTUS MC9700 Customer: Crane No: Delivery No: 910 ID Code: 10 Frequency: Del. Date: MHz W03 MANUAL MC9700 Del. no. Ver.
MANUAL MC9700 Del. no. Ver.
TRANSMITTER ON Pull out the stop button (EMERGENCY STOP) and the transmitter will make a self-test during 0,5 seconds. The operation indicator lamp starts blinking and the transmitter is on. MAIN CONTACTOR ON Then the transmitter is on press the signal button and this actuates the Main Contactor in the receiver and the traverse is ready for operation.
MICRO RUN (NOT SIMULTANEOUS) Set the selector for MICRO/NORMAL in position MICRO. The micro-run movements are only at lowest speed in micro-run mode irrespective of the deflections of the manipulator. The other functions are working just as in ordinary runs. The manipulated movements are looped so that only one movement can be operated at a time. SIGNAL A signal can be emitted at any time during the run and is obtained as long as the push button switch is depressed. STOP Depress the STOP button for STOP.
AUTOMATIC SWITCH- OFF FUNCTION The transmitter is equipped with automatic switch-off function, switching off the transmitter after 2, 5, or 15 minutes. After the latest use, depending on what period of time has been looped, it is also possible to loop for continuous drive. The indicator lamp for operation goes out and the Main Contactor is de-energized. For renewed activation of the Main contactor restart is required, press the stop button and pull it out again, and push the signal button.
TRANSMITTER LED INDICATIONS If the transmitter under start up or under drift detect a fault in any self tests it will indicates with a continuously red light. After what the transmitter closed down. If it indicates continuously yellow light when you start up the transmitter it will be something fault with some of the manipulators.
CHARGING INSTRUCTIONS ∗ ∗ ∗ ∗ ∗ ∗ ∗ The battery has got power for 10 hours continuous operation. Charging time 1,5 hours (quick-charge) there upon changes to maintenance charging which does not need supervising. The charging device has LED indication for quick charge (fixed red LED) or maintenance charge (flashing red LED). Take the battery out of the charger before the main-connection is disconnect.
INSTRUCTIONS FOR CRANE OPERATORS These instructions have to be followed. Marked ! 1. ! Check that the radio transmitter operates on the crane which you are going to drive. Check the marking. Check the function of the radio transmitter. 2. ! Check that no unauthorized person is on or at the crane when you start to drive it. The blocking device at entry of the crane should be closed. 3. ! Check the position of the symbols for driving direction (crane-trolley travel). 4.
. ! If you loose control of the crane movements, release the pushbuttons to obtain the zero position in order to stop the crane. If still it does not stop, actuate the STOP function. 10. ! Find out where the crane's main power disconnected is in order to be able to quickly switch off if required. 11. ! Never hand over the transmitter to anybody who has not undergone training in radio-control crane operation. 12. ! After completed operation you should always switch the transmitter off with STOP.
FCC Identifier OG4MC97 This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user´s authority to operate tne equipment. MANUAL MC9700 Del. no. Ver.
