User's Manual

Category:
External
Product/Project:
INSTALLATION
Page:
11 (12)
Subject:
INSTALLATION MANUAL SESAM 6099 TRANSMITTER
Document ID:
939045-000
Date:
2008-01-18
Written by:
Henrik Ring
Checked by:
Anders Modig
Approved by:
Henrik Ring
Version:
A1
ÅKERSTRÖMS BJÖRBO AB, SE-780 45 BJÖRBO, Sweden
Phone [phone], Fax [phone]
Vat No SE556153982501 Registrated office BJÖRBO
www.akerstroms.se
8. Frequency Channel Selection
The transmitter and receiver channel is set by the internal 8-pole DIP-switch (SW1) according to
table below. 30 different channels can be selected. Both the transmitter and the receiver must be set
to the same channel. The Sesam6000c receiver channel can also be set via RS232 with the
command SET /C.
DIP-switch (0=off ; 1= on)
Channel Frequency
MHz
1 2 3 4 5 6 7 8
80 434,050 1 1 1 1 0 0 1 0
82 434,075 1 0 0 0 1 0 1 0
84 434,100 1 1 0 0 1 0 1 0
86 434,125 1 0 1 0 1 0 1 0
88 434,150 1 1 1 0 1 0 1 0
90 434,175 1 0 0 1 1 0 1 0
92 434,200 1 1 0 1 1 0 1 0
94 434,225 1 0 1 1 1 0 1 0
96 434,250 1 1 1 1 1 0 1 0
98 434,275 1 0 0 0 0 1 1 0
100 434,300 1 1 0 0 0 1 1 0
102 434,325 1 0 1 0 0 1 1 0
104 434,350 1 1 1 0 0 1 1 0
106 434,375 1 0 0 1 0 1 1 0
108 434,400 1 1 0 1 0 1 1 0
110 434,425 1 0 1 1 0 1 1 0
112 434,450 1 1 1 1 0 1 1 0
114 434,475 1 0 0 0 1 1 1 0
116 434,500 1 1 0 0 1 1 1 0
118 434,525 1 0 1 0 1 1 1 0
120 434,550 1 1 1 0 1 1 1 0
122 434,575 1 0 0 1 1 1 1 0
124 434,600 1 1 0 1 1 1 1 0
126 434,625 1 0 1 1 1 1 1 0
128 434,650 1 1 1 1 1 1 1 0
130 434,675 1 0 0 0 0 0 0 1
132 434,700 1 1 0 0 0 0 0 1
134 434,725 1 0 1 0 0 0 0 1
136 434,750 1 1 1 0 0 0 0 1
138 434,775 1 0 0 1 0 0 0 1
Table 1 Frequency channel table